The wLS broad-band LED illumination unit is designed to provide a long-life alternative to traditional Mercury and Mercury Metal Halide fluorescence excitation sources. The broadband excitation covers common fluorophores, ranging from DAPI to Cy5, allowing existing filter cubes and protocols to remain in place. Unlike other broad-band LED solutions, the wLS provides rapid control over individual excitation LED wavebands (Ultraviolet, Blue and Green/Yellow/Red). This enables the use of multiband pass filters instead of individual filters, followed by slow mechanical filter changes during multi-label imaging.
LED excitation provides many advantages over traditional fluorescence light sources, most notably eliminating one source of toxic Mercury from the lab. It also lowers operating cost with its 25,000 hour LED lifetime, which consumes 80% less energy.
A control handset is included which provides instant on/off and intensity control in increments of 1% to 100%, over each individual Ultraviolet, Blue, and Green/Yellow/Red (GYR) excitation waveband. When used with a QImaging camera, the on/off control is easily accomplished with the cameras expose out signal and the wLS TTL input. The wLS further extends control to popular microscopy automation and analysis packages with its USB interface.
Upgrading an existing microscope is easy. The wLS supports a comprehensive range of microscope adapters that fit to current and older microscope systems. A 3mm liquid light guide option is available for hard to adapt or non-microscope systems.
LED lifetime to 25,000 hours
No dangerous Mercury lamps to change every 300 hours
Excites common fluorescence labels in single and multiband sets
No need to change filter sets
Ready to go when you are
Stable with minimum warm up and cool down
No mechanical shutters to wear out
No ND filters required
Stable and repeatable
Maximizes light coupled to specimen
Produces optimal uniformity across FOV
Minimal alignment
Easily integrates into your experiment
Easily share a light source between microscopes
Illumination: White light or individual UV, Blue or GYR wavebands
Intensity Control: 1% steps from 0 – 100%
Attachment to Microscope: Direct Fit or Liquid Light Guide
Triggering: TTL for on/off control of selected channels using a BNC connection;Switching time < 30 uS
Software Control: USB control for Windows 7, supported in most high end imaging packages
Power Requirements: 100-240V a.c. 50/60Hz, 2A
Power Consumption: 2W (standby), 80W (full white intensity)
Single and Multiband Wavelength Sets: Select UV wavelength to match your existing DAPI filters:
Singleband for DAPI excitation at 365 nm,
Multiband for DAPI excitation at 400 nm